Headphones wall hanger

Headphones wall hanger.

Because we don't like headphones sitting randomly on a table. They just look bad, right? :)

This helps tidy your room or workspace and should work for a wide variety of headphone models.

This design does not have holes to fix the part using screws, we used a 3M VHB-ish tape instead, which provides a reliable hold. We have had a couple of hangers around the house for months and they are holding up just fine.
Make sure you use a reliable adhesive to fix the hanger to the wall

If you would like us to add a screw-mounted version, let us know in the comments ;)

Updates

2023-02-03: We also made a special holder for the Sony Pulse 3D headset!

2022-08-28: We have included two additional versions, with longer support for wider headphones.

Print Settings

You can print this at any layer height, with 10% infill. We used a 0.4 mm nozzle.

The print requires no supports.

Filament
Fillamentum PLA Extrafill Vertigo Gray

Follow us / support

Did you like this design? Follow us on Instagram! We are @twothingies

If you print this, let us know! Tag us on Instagram and we will feature your print :) Or you can leave us a review here. It really helps us improve our models 👍

If you really like what we are doing and want to support us, you could buy us a coffee or two!

Selling prints of our designs

Please be aware that our designs are available for free for non-commercial purposes only. 

If you would like to sell 3D prints of our designs in your store, you can join one of our membership tiers!

If you have other ideas, we would be happy to discuss that with you! Please send us a message if you are interested.

Disclaimer

Due to the different properties of 3D printing filaments and the tolerances of different machines, you might need to scale up or down some of the print files, in case they don't fit when you print them.