Dolce Gusto Capsule Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stackable capsule holder for Dolce Gusto capsules. Build as many levels as you want.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 19
- Makes
- 1
- Views
- 135
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I made a capsule holder for Dolce Gusto Capsules, that is both very easy to print, assemble and is versatile, as you can print the number of levels that you want (I have only tested with three).
It is a small footprint capsule holder, carrying two capsules per level, so it won't take up all the space on your countertop, while providing benefit and flexibility.
I printed it using Flashforge PLA on a Flashforge Adventurer 3 Pro 2 (15x15x15 cm build area) so the 3D model prints well on smaller printers.
The Base prints as is, while for the 2-slot holder, I used 3mm brim (set “brim inside holes” to “no”) to avoid warping on the sharp corners of the outer capsule slot. Also, I used a brim for the top end cap, but not sure if it is needed.
215 C PLA temp
65 C bed temp
I used 30% infill for some extra rigidity
Check out the creation, printing and assembly process over here on my channel:
Part 1:
Part 2: