1 / 8
SpeedyBee Mario 8 Fold Custom Parts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Newly designed TPU parts for Mario 8 Fold.
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 617
- Makes
- 0
- Views
- 1,769
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Newly designed 3d custom parts to fit Mario 8 Fold by SpeedyBee.
- Side plate (mirror it in slicer for other side print upside down with snug support).
- Landing skids (just print 4 with 100% infill).
- Antenna array for 2x SMA connector and Bardpole fitting GPS from Matek M10Q.
- Second Version of antenna array with little side plates to make drone more enclosed.
- TBS Immortal-T is held by two small rubbers you can also use heat shrink.
- Cap for GPS (tolerances of antenna array and cap are for press fit with 0,12mm layer)
- Mount for TBS Crossfire Diversity Nano RX to put between sidaplates, also press fit.
- Fron Air Intake closing the build and tunnelling air inside.
- Matek Optical Flow & Lidar Sensor mount under the drone with middle plate.
- DJI O4 Pro riser to pass cables and antennas extension under VTX.
- Between middle plates is hidden Vifly 2 Buzzer with HGLRC Mini Led on sides.
Recommend printing all with 0,12mm layer.
I've used TPU from Fiberlogy - Mattflex 40D it gives nice semi matte finish hiding layer lines.