Aeropress Storage/Travel Cover with Sealed Filter Compartment
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Aeropress travel cap that you can stuff a few spare filters inside a closed filter storage compartment.
- Rating
- 4.333 / 5
- Likes
- 119
- Downloads
- 205
- Makes
- 4
- Views
- 2,411
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Awdemuth(thngvrse) made a really nice Aeropress travel cap that you can stuff a few spare filters inside, but I wanted one with a separate filter storage compartment- that will keep the filters clean and dry. My Aeropress comes with me on camping trips, and is often stuffed in my backpack where it can sometimes get dirty and wet. I got out the calipers and modeled a cap in fusion that fit the criteria.
This thing has a few important features:
-allows the plunger to fully click into place for storage with the seal uncompressed.
-allows drainage/air circulation around the plunger face, so can be put away while still wet.
-storage for up to 25 filters in a separate compartment.
-aeropress filter cap gently compresses filter compartment to fully seat the TPU gasket.
-filters are stored clean/dry and protected from the environment.
-knurling on the surface where you touch it, cause knurling feels awesome.
The handle and lid have a generous tolerance for fit, and are assembled with CA glue.
The body and lid and handle are printed with PLA, but I used TPU to print the gasket seal (see printing notes).
Body:
Supports are...not really desired- but I was having unsatisfactory results with the bridging layers that sit over the plunger. So I modeled a triangle that barely contacts the underside. Use Prusa Slicer to force supports in this area only, and the underside comes out beautifully smooth. Slow down your bridge speed for the locking tabs on the top of the part.
Lid:
Print the Lid upside down with no supports. It should be a solid part. I used Pursa Slicer to insert a color change at height=1.4mm. At this level, I changed the filament to a flexible TPU with similar print temp as PLA to print the gasket seal.
Handle:
I also printed the handle upside-down. You can add decorative color layers as desired.
EDIT: after about a year using this, the tolerance has loosened up some and it no longer screws tight to the aeropress. I suspected creep from ambient heat just barely deformed the shape over time. So I followed the process from makers muse to anneal the PLA in the oven: packed in a bowl of salt to preserve shape during annealing. Testing the procedure and measuring against the original model shows me how much shrinkage I would have in the X,Y,Z directions. I then printed a version scaled up by that percent, annealed it, and the final part is accurate dimensionally and much more stable against any heat creep. Its a bit of a process to go through, but this final part has been riding on top of my aeropress around the world for two years now and has been solid.
