Axminster Wood Lathe Chuck Pen Jaws
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wood lathe chuck jaws used for drilling pen blanks
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 163
- Makes
- 0
- Views
- 697
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
These are a set of pen jaws, based on the idea of the Axminster Pen Jaws at this link.
They can be used with Axminster wood lathe chucks (I've only tested with the SK114, but they should work with others). They obviously will never be as strong as the Axminster stainless steel ones, but they're a lot cheaper! They seem to be strong enough for the relatively light forces involved in drilling pen blanks.
To maximise the strength, I printed in PETG with 6 perimeters and 40% in-fill. That does mean that it takes a long time to print the jaws. Reduce those parameters as you see fit.
Use at your own risk: I take no responsibility if you overtighten the jaws or they disintegrate for any other reason. Always wear a face mask and stay safe!
Also included is a STEP file of the base plate, upon which I've based quite a few different sets of chuck jaws for the Axminster chucks. The STEP file includes four bases (although I tend to model based on one and then either just print four copies or do a circular pattern to make the four copies in the model) - the four bases give a good centre point upon which to base any circular features.