RC Car 2n1 Modular Ramp 2x2 default V2.5 for 1/10 scale or smaller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Files Updated. For a Full tutorial please check playlist at bottom of description.
- Rating
- 3 / 5
- Likes
- 17
- Makes
- 0
- Views
- 492
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Standard Digital File License
Takes around 9-10 rolls on my settings which is around $100 if you get 10packs on amazon. My goal is to get this ramp mass produced to be able to sell it for what a hq 4s battery cost. Thanks in advance for your support. Any questions email for a faster response as I dont get notification on here as of yet, until I figure it out.
Ramp can be made into 2 smaller ramps. Updated pics of said smaller ramps will be updated today 2/16
Version 2.5 Bigger nuts and bolts, less nuts and bolts over all. Middle braces for extra support. Less over all pieces. Bigger pieces for 256x256 printing. 220x220 still available upon request. Bolts DONT break now.
PLA will work, but I wouldnt leave PLA in the sun. I would use High speed PETG.
256x256 minimum print area.
Very easy to put together.
Print however you want. With that being said, heres how I print for ramps that I sell.
All panels, brackets, and main bolts are labeled A,B,C etc.
Heres what I would print at.
Dowels .28, 100% infill
Panels .4 nozzle, 3 floors, 3 walls, 3 surfaces, 15% infill Gyroid
Brackets/Stand = same as panels depending on orientation only 2 walls needed
Bolts .28, 20% infill Gyroid, 5 walls, 2-3 floors and surfaces,
Nuts .28, 15% infill, default walls etc is fine. Ive never had a nut break even when they were small.
Theres no need to tighten the bolts 'Real tight', once the bolt is not loose no need to tighten further. If you break the tool, you were trying to tighten more than it needs to be. I have yet to break a tool even when the tool is printed in PLA. Tool head must be printed at .28 or lower nozzle and no less the 60% infill. I never noticed a difference between print order like outside to inside or inside to outside. But, I set it to outside to inside jic there is a difference. I focused on the tolerance of the nuts n bolts as I wanted to make sure it was the least amount of turns needed with minimal resistance while still having a strong grip.
A Bolt = 58
B Bolt = 6
C Bolt = 8
Nuts 66
Ramp Brackets = 6
Refer to pics to see the number of brackets you will need as having the middle stand brace is optional and dependent on your needs.
Dowels = you only need 2 per, but I made a boolean in case you wanted add 3. So 24 if youre only using 2 each.
Any questions feel free to ask and subscribe to my YT page for updates, videos, and future upgrades.
Refer to pics for diagrams and ramp Ideas.