Air purification system using ALVEO3D P3D-R HEPA Filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
System for your 3d-Printing Setup to filter the air inside your enclosour.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 21
- Makes
- 0
- Views
- 267
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution

This is an active frame for a HEPA Filter by ALVEO3D. It is designed to suck the air threw the filter so the P3D-R Filter is used.
For a fan I guess any 12cm 12V PC-fan could be used as the power supply is feaded threw one of the mountig holes of the fan itself and the case has a corispondig hole at the front.
I used a Delta Electronics AFB1212HH fan I had laying arround.

The fan has its own frame made from TPU in my case to try dampening some of its vibrations.

The filter is placed in its own frame direktly on top of the fan to force the air to pass threw the filter.

Everything is closed up by a printed grill wich hase the same dimentions as the filter so no air shoud leak around the filter. I used M3 threaded inserts and bolts.

To get the Power to the fan, controling its speed and get it up to the level of the printbed I designd a little stand for the filtercase. In there I put a simpel PWM control bord and the nesesserry plugs and wires to get everythins up and runninn.
You could of course just wire the fan directly to a 12V powersupply if you want to keep it simple.
I already printed some few hours with ASA with this setup enabled and I couldn't smell anything. So it seems to work properly :-)