Funko Hexagon Riser Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hexagonal raiser for Funko pops.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 40
- Makes
- 0
- Views
- 252
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a riser for some of my Funko's, they're displayed in Ikea Billy bookcases. The idea was to fit as many as I could and have them fit as good as possible.
Four of these can fit perfectly in a single door Ikea Billy bookcase. I also used the to showcase other things, thus being able to add more without it looking too crowded.
The height I found to work best is 12 CM, but I also created a 10 CM one at one point to try and make them use a bit less filament. The difference is about 13g, not much but it adds up over multiple models.
If other heights are needed it can be easily edited, happy to help if needed.
The ones shown in the pictures are the 12 CM ones.
5% infill, Gyroid, 3 walls
Print upside down, no supports needed.