1 / 4
Torsen T-2 differential for lego
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Torsen type 2 style limited slip differential for lego.
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 108
- Makes
- 0
- Views
- 661
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Attribution — Share Alike
Torsen type 2 style limited slip differential for lego. Just like in real one, you have to stress it to get the limited slip action.
Check out my other models from limited slip differential for lego series:
Detroit Truetrac/Quaife https://www.printables.com/model/1259805-truetrac-style-differential-for-lego
Torsen Type 3: https://www.printables.com/model/1222782-torsen-t-3-differential-for-lego
You will need:
-3x m2.5x15mm screws, 10-20mm will do too.
Assembly:
- Remove printing defects, you may need sand flats of the gears.
- Place drive on a table, and place a short gear on top of it, doesn't matter which one.
- Place divider on top of the gear mentioned previously, flat side up.
- Divide tall gears into left and right, determine which of the two meshes with the short gear you haven't placed yet placed.
- Place tall gears that mesh with unused short gear, shorter side down in symmetric order
- Slide 3 remaining gear in remaining holes
- Place the remaining shorth gear on top of divider
- Close the mechanism with top
- Screw screws in, loosen if it's too tight.