5.1mm Furniture Pegs / Shelf Pins
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I had a shelf with too many boards and not enough pegs. 5.1mm x 16mm x 10 pegs
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 23
- Makes
- 0
- Views
- 91
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I had an IKEA shelf with too many boards and not enough pegs.
5.1mm x 16mm x 10 pegs. 5mm was too loose - 5.1 is snug.
The pegs are 8mm + 1mm washer + 7mm = 16mm long.
If you need other sizes it should be easy to scale the peg in your slicer.
The pins rest on tiny pins to raise up the print from the bed and widely spaced because I had a hard time printing tiny things. I had to make sure every peg was supported on it's own bed.
Most of the prints failed until I tried a few ways to do it. I would print 10 pegs and maybe 3 were good, until I fixed it for you. Now most of the pegs are successful.
To make it stronger I used 70% infill, lay the peg horizontal, and rotate it a bit in top view.
< If you print the pegs vertically they are weaker. When I put one in the hole it would snap if I tried to take it out. >
I suggest printing 1 group of 10 at a time. Better to have 10 fail than 50.
Printing 10 pegs takes my AnkerMake printer about 30 min.
In the photo, only 6 of 10 were good.
That is because I am experimenting with Silk filament. I am sure if I used regular PLA I would get better results. The model is fine.
