Adjustable Pushblock
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
8x M6 nut
Optional 2x 5mm m6 heat inserts.
8x M6 20mm
2x 20-30mm M6 Phillips/Allen Head
Rubber Coating/Tape
Print one of each model but two of each of the knobs and spacer may be required for the handled depending what
The Nuts are embedded, so make sure you add a pause in the think wall and main body models at the correct times. There is also a sacrificial layer to improve printing, so cut it out with anything sharp or force the bolt through it.
Can add a 5mm deep m6 heat insert to the thin wall, but I doubt it will be strong enough to put any major force on it.
Add rubber to the feet, I used some foam seal tape but flex seal or similar will work better
Use the microJIG GRR-RIPPER-style Handle from @NightMyst_179437
https://www.printables.com/model/591443-microjig-grr-ripper-style-handle