Schuberth C5 Chin Bar Lock Pin / Kinnteil Verriegelungs Stift
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
In case you pushed down the chin bar while it was locked Wenn ein verriegeltes Kinnteil herunter gedrückt wurde
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 164
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
The chin section of the Schuberth C5 can be locked. If the chin section is pressed down with force while it is locked, it will break.
Use a Torx T10 to unscrew the screw on the left side of the helmet. Use a Tox T8 to unscrew the four screws. Replace the broken pin with the 3D printed replacement pin. Reassemble everything. IMPORTANT: Use blue thread locker to secure the large screw again.
Das Kinnteil des Schuberth C5 kann verriegelt werden. Wenn das Kinnteil mit Gewalt nach unten gedrückt wird, während es verriegelt ist, geht es kaputt.
Mit einem Torx T10 kann man die Schraube an der linken Seite des Helms aufschrauben. Mit einem Tox T8 die vier Schrauben heraus schrauben. Den kaputten Stift gegen den 3D gedruckten Ersatz Stift austauschen. Alles wieder zusammenbauen. WICHTIG: Schraubensicherung blau benutzen um die große Schraube wieder zu sichern.