1 / 4
1979-1980 SA22C Rx-7 A-Pillar trim 8871-68-171 — image 1
1 / 4

1979-1980 SA22C Rx-7 A-Pillar trim 8871-68-171

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A-Pillar replacement for SA22C Rx-7

Rating
0 / 5
Likes
6
Downloads
29
Makes
0
Views
177
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted to install gauge pods but wasn’t willing to drill into what is now a 40+ year-old, relatively rare part. So, I set out to recreate it.

The first challenge was the A-pillar’s unique curvature along the body, which doesn’t lend itself well to 3D printing. To address this, the print is completely flat. Since the model is too long for a single print, I split it into three pieces, joined by flat slats that allow the finished print to flex into the required shape.

Printing:

Print each piece with painted supports only on the mounting hole.

Avoid default supports, as they may fill in the space where the slat slides in, making removal difficult.

Orientation for printing:

Bottom: Complex end facing up

Top: Top side up

Middle: Wider end facing down

Slats: Flat side down (This ensures layer lines run perpendicular to flexing, preventing snapping.)

Assembly:

Apply a small amount of adhesive to the slats.

Slide the pieces together and allow the adhesive to set.

Install the assembly into the car, starting with the bottom piece first.

Note:

This orientation is for the driver’s side. To print for the passenger side, mirror the parts in your slicer.

Tags