1 / 2
Codenames Duet box
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.83 – €4.68 net (excluding VAT)
For file: lid_0.2mm_PLA_MINI_4h10m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.25 excluding VAT (range midpoint).
- Weight reported by the author
- 55 g
- Print time reported by the author
- 4.17 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A storage box for Codenames Duet. Smaller than the original box, and keeps pieces organized.
- Rating
- 4.5 / 5
- Likes
- 11
- Downloads
- 76
- Makes
- 1
- Views
- 631
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Design notes
- I used two magnets—8 mm (D) × 3 mm (H)—to keep the lid secure, so that the precise fit of the lid is not as important.
- I printed a lid with only 0.1 mm clearance—which is too tight to fit as-printed—because I preferred to sand down the contact surfaces a bit. This helps reduce the annoying "ripping" sound when taking the lid off, which seems to be caused by parallel layers moving past each other.
- My Prusa Mini has some issues with nozzle pressure build-up. So I printed the two pieces separately, to avoid the solid infill layers of one piece affecting the perimeter surface of the other. This may not be an issue for you, in which case you could print them together.
- I placed two identical cut-outs in the lid to accommodate the word card stand regardless of which orientation the lid is closed in. But then I ultimately printed everything with a rear seam, which makes it trivial to know which orientation is correct.