1 / 3
cr6 filament guide
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
cr6 filament guide to replace broken filament sensor
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 105
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I replaced the filament sensor since it wasn’t working correctly.
Previously, I had made a mod that caused the filament to scrape against the extruder side, which led to a buildup of small plastic particles over time.
I printed this with 100% infill, but 50% should be just fine.
Wall line count: 4.
Print time for both parts was approximately 1 hour and 50 minutes using my settings (50 mm/s, stock setup).