Nebula Capsule 3 Laser Projector Tabletop Stand

So you just bought yourself a fancy Nebula Capsule 3 Laser projector and the darn thing doesn't even come with a stand and it wobbles too much on the small tripod you had lying around, eh? Well have no fear, because I had the same problem and came up with this lovely stand.

All parts print with no supports. You will need one of each part except for two knobs. I recommend three perimeters for strength. Good-old PLA should be fine.

The only hardware required are two M6x16 or M6x20 bolts with 10mm hex heads. Longer sizes will work but will stick out from the side of the knobs and your friends will make fun of you for it. You also have the option of using a short ¼-20 tripod screw to secure the Capsule 3 to the cradle.

To assemble:

1. Place the cradle inside the stand and push the hex bolts through the two parts from the inside. The hex head should sink inside the cavity of the cradle.
2. Thread the knobs onto the bolts.
3. Install the Capsule 3 into the cradle, tilt the cradle to allow access to the bottom. Optionally install a very short ¼-20 tripod screw to secure the Capsule 3 to the bottom of the cradle.
4. Place the crown on the top of the cradle to lock the Capsule 3 in place. The parts will wedge together because they are tapered.
5. Profit!