Diversity antenna mount (frsky rx)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is another V 90° antenna mount for Frsky and others RX that got diversity antennas ( X4Rsb, D4RII, X6R ... most…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
This is another V 90° antenna mount for Frsky and others RX that got diversity antennas ( X4Rsb, D4RII, X6R ... most of Frsky RXs but not the X8R with pcb antenna), specified for the ZMR250 carbon frame (top rear part). I designed it with Fusion360 and sliced/converted in Cura, no modification are required, just i had to 2.5 mm drill again holes for tubing inserts. I didn't wanted to enlarge more than this those holes cause whole part is very tiny already. For the tubing i used some ears cleaner sticks that are perfect for this purpose, 2.5 mm diameter and 1.3 inner diameter that allow the antenna wires to pass through perfectly. Of course you will need to remove cotton from each side of the ear sticks before to use them ;-). That's all, no glue are required.
p.s. My printer is an ANYCUBIC i3 MEGA, couldn't find in the printers model but i see there is Anycubic brand name but need to update by inserting that model.
Print Settings
Printer:
ANYCUBIC i3 MEGA
Rafts:
No
Yes
Resolution:
0.2
25%
Notes:
The printer used is an ANYCUBIC i3 MEGA with PLA (1.75mm black) filament. I positioned the object with base on table like it would be normally placed in the ZMR frame. Supports are needed but the print time was just 23 minutes. It's a very small part.
Category: R/C Vehicles