Advan SA3R V1/G1 Kit - Centre Cap, Nut, Tool and Coin Blank
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Advan SA3R G1 full accessory kit. Worked off 17", Should also fit 18", Includes *untested* 15-16".
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 249
- Makes
- 0
- Views
- 813
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
Here's my take on the Advan SA3R accessories, Designed to be easy to print without supports.
I'm sure it's not perfect, I don't have access to the real deal, However I did take measurements off my 17x8 +35s and 17x9 +38s.
Measurements were taken with a bolt on spacer attached with 35mm studs, Should hopefully suffice for most vehicles wheel studs. My Crown Athlete V has 24mm studs.
I have included .STLs, .STEPs and a .F3D file with the original models for easy adjustments if they don't quite work for you.
- Centre Cap for 17-18" - It was made by just adjusting an initial side profile then revolving it. 140mm outer diameter. Very easy to make changes to.
- Nut - It was made to be a 64mm nut, M56 x 1.5 thread on the inside. Took a lot of takes to get the right thread clearances. Tested on a pretty rusty thread so results may vary.
- Nut Tool - This was made specifically with my own nut, Clearance of 0.2mm either side.
Includes holes for 2x M3 x 35mm screws to some reinforcement.
Not sure if it will work on the OEM nut, Feel free to adjust or scale to your needs. - Coin - The coin is simple, It's blank but the correct size, Would recommend making some cool, model specific logo or something.
Doesn't include the small holes for removal with circlip tool like OEM. - Centre Cap for 15-16" - Now I have also included an UNTESTED centre cap for the shallower 15-16" wheels, I had some measurements that indicated that it was about 10mm shallower, So I simply scaled the Z axis of my own cap to be 10mm shorter, No guarantee this will be close at all.
Wasn't a fan of seeing models only available behind a pay wall, So I made my own.
Feel free to sell prints of these but I just wanted to put these up for free to help others.