Terminal-block Endcap - ST1.5
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Endcap for phoenix contact terminal blocks (ST1.5). To protect against touching the open side of the terminal blocks
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 29
- Makes
- 0
- Views
- 237
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- GNU General Public License v2.0
If the phoenix contact ST1.5 terminal blocks (Reihenklemme in German) get mounted to a DIN rail they will leaye one side open. To protect against touching an endcap is needed.
Sure you could buy them. But you could also print them. If you are worried about fire then you could also print them in flame retardand filament. For industrial use this is probably not the best solution but for privat use (in a printer) it will definitly work.
Printing:
Printed in ABS and PA. Other filaments are not tested yet.
- Layer width 0.6mm
- Layer thickness 0.3mm
- 3 perimeters
- 5 bottom-, 5 toplayer
- No brim to make sure the contour fits perfectly
- Would use some elephant foot compensation to make sure the contour works out.