Spinning Top (PLA with PETG for support interface)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Spinning Top made of PLA that uses PETG for the support interface
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 36
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple Spinning Top.
I made this model to test the multimaterial capabilities of a MMU or AMS. That means this model uses PLA for the model and PETG for the support interface.
Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand and dry filament. An multimaterial system like MMU is necessary to use PLA and PETG simultaneously.
Print settings:
Use the 0.16mm settings and reduce all speeds a little bit for better quality. Concentric top, bottom and infill patterns will provide a smooth result. Three walls, five tops + bottoms and 50% infill are recommended. Turn on hybrid tree support and set the top z distance to 0. Switch to PETG for the support interface.
See my 3mf print profile (Bambu Studio or Orca Slicer) for more details.
Again:
This model is designed to use PETG for the support interface. My print profile will not work without PLA AND PETG.
If you want to support me you can leave a tip at ko-fi.com/blecheimer.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0. The shown model must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.