1 / 5
R1, R2, R3 Mini Joiner Biscuits for Older Ryobi DBJ50 Biscuit Cutter — image 1
1 / 5

R1, R2, R3 Mini Joiner Biscuits for Older Ryobi DBJ50 Biscuit Cutter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Alternative biscuits for harder to find and costly compressed biscuit.

Rating
0 / 5
Likes
5
Downloads
39
Makes
0
Views
197
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution

I bought the Ryobi at a thrift store without realizing it was a mini joiner. Finding and pricing R2 biscuits at about 20 cents each was high considering I can make them at 10% of that. I made them using 20% wood filled filament. That probably will not help much for glueing them in but the purpose is basically alignment of the wooden parts. The thickness is 2.4mm (0.095) which is a tight fit. Printing directly on the build plate with squish they can come out fitting loose. I suggest a small frame raft for adhesion and consistent thickness. Now the last item pictured is a three sided sized sanding block. With a raft there will be a raised texture. Use the block with the right size indented R size to move the biscuit across a sheet of sandpaper, R number up. A few strokes across the paper is all that is needed. 

The last thing to consider is that I bought the Ryobi used. The cutter may have lost some of its edge due to wear creating a narrower kerf. With a new cutter these biscuits may be a little loose. Adjust Z size slightly to compensate. I used 4 walls top and bottom with 30% infill.