Weber Grill Foot Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.54 – €1.88 net (excluding VAT)
For file: Grill_Foot_Guide v4_0.4n_0.2mm_PETG_COREONE_1h8m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.71 excluding VAT (range midpoint).
- Weight reported by the author
- 36 g
- Print time reported by the author
- 1.13 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Two of these will prevent your traveling Weber from sliding around.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 108
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
I wanted to transport my Weber grill without placing in a box, a very big box. I went that route last year and wanted an improvement. If only I could set the grill on top of my storage bins and prevent it from tipping, etc. Well, some improvised brackets, a reused plywood board and an old bungie cord did the trick. We leave on a 8,000+ mile camping trip trip (TOMORROW) and will reap the success or failures of this design. Wish us luck.
Printed on a CoreONE with inexpensive PETG at 15% fill. There was a little stringiness but I haven't had time to dial the filament in.