Kobalt 40V Battery Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mountable holder for Kobalt 40V batteries
- Rating
- 5 / 5
- Likes
- 14
- Downloads
- 85
- Makes
- 3
- Views
- 308
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
I needed a way to manage and store my 40V Kobalt batteries. Print shown was completed in PETG. This held up fine in an unconditioned garage during a Georgia summer. I have these spaced 19mm/.75" apart. This allows plenty of room to pull out the battery. The included spacer helps with consistent spacing during install. The tab at the bottom covers the charging ports. Since I only have one 40V charger I printed two in red, that is where I store my batteries that need to be charged. I designed this for an easy loose fit, while still allowing the rails to hold the battery securely. I designed this with four screw holes but I tried a few with only two screws and they are holding up fine. The models shown were completed with a 15% Grid infill. I printed them with the backside down so I used supports for the rails on the side.