1 / 4
H2D Exhaust Fan Silencer / Muffler with Bambu Logo — image 1
1 / 4

H2D Exhaust Fan Silencer / Muffler with Bambu Logo

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

H2D Exhaust Fan Silencer / Muffler with Bambu Logo

Rating
5 / 5
Likes
26
Downloads
90
Makes
2
Views
1,279
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Fan Silencer for the New H2D

This fan silencer is designed for printing at a 0.16 mm layer height without supports. It should work with any layer height, but supports may be necessary for the four screw holes.

 

For installation, you will need four M3×8 mm screws; optionally, five 5×2 mm magnets can be attached (pressfit, no glue needed).

 

It requires approximately 170 g of ABS and about 6 hours of print time.

 

Note: Because the H2D is equipped with an active chamber heater that can reach up to 65°C, it is essential to print the silencer in ABS or another similarly temperature-resistant plastic (ASA/PC/PA, etc.). DO NOT PRINT IN PLA. PETG should work but its not recommend

Tags