Retro CRT Lithophane Holder: Lith-o-vision 2000
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A lithophane holder shaped like a CRT with a built-in LED holder. Use a 100×75×3mm lithophane.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 34
- Makes
- 0
- Views
- 229
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Share Alike
A holder for a 100×75×3mm litophane with a built-in LED holder. It is designed to be used with one of these LEDs:
Search for “1W LED chip bulb” on Amazon/Ebay etc. to find one of these.
🪛 Assembly
I used a 10Ω (1W) resistor in series with the LED and soldered up the circuit to a USB cable that I chopped the end off of and put through the cable hole at the back:
I then slid the LED and the resistor into place and hot glued everything down (it should be fine, the LED doesn't get that hot). If you want to reduce the amount of light leakage, you can make a “funnel” around the LED to direct the light, although it isn't too necessary so I didn't make it a part of the model.
Finally, I snapped the lithophane in place (the clips should hold it in place) and put all the pieces together (it's a friction fit).
ℹ Print tip
Print the front and back parts nested like so:
