Aerosol Can Holder - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
increased space in holes. Added rear hole for 60x10x3 magnet. extruded mid section thicken.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 27
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Wall-mounted holder for aerosol cans, wd40, brake cleaner, carb spray etc..
REMIX:
Redid the magnetic holes to space magnets better for tolerance.
Extruded middle section, found this to be too thin for what I needed and made it a bit stronger.
Extruded hole for rear magnet, to be used instead of screw to wall option. Magnet to hang on toolbox or on side of lift, ladder, etc.
Requires:
https://a.co/d/aQbkbBT
Rear magnet if not screwing to wall, required (1) 60x10x3 magnet* as seen in pictures.
https://a.co/d/c151HCW
Glue : DAP rapid fuse super glue is my goto. A little drop is all that is needed.
https://a.co/d/2fRypt4
IMPORTANT:
Check that your slicer part position and height.
My slicer is Bambu Studio. Cura might not position it correctly on plate.
On bambu slicer I did use supports in order to support areas of cuts, suggest you add in cura.