Rolling Pin Holders Top Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
remixed to various sizes and top mount option
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 0
- Views
- 82
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Don't ask me why, but we have 3 rolling pins, all different sizes. I had originally planned to use the holders to prop up the rolling pin, rather than the handles. So I measured and resized 3 different brackets. I did not measure the diameter at both ends. Our 76mm rolling pin is actually 80mm on the other side! I eventually found a better spot to mount the two larger ones which needed a top mount.
Word of warning, I didn't put much thought into how I would get a screw driver into the top mount. You will need some short screw drivers, or an L shaped driver. I ended up using a hot end wrench to hold a screw driver bit.
I used a combination of MS 3D Builder and onshape to remix this. You can edit the onshape model, but it's a mess