BMW R1150GS Navigation Phone Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€6.06 – €7.40 net (excluding VAT)
For file: arms smothed_0.2mm_PETG_MK3S_7h6m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €6.73 excluding VAT (range midpoint).
- Weight reported by the author
- 82 g
- Print time reported by the author
- 7.1 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Bracket to hold your phone or navigation above instruments on BMW R1150 GS motorcycles.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 144
- Makes
- 1
- Views
- 707
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Bracket to hold bar for your navigation or phone on BMW R1150 GS motorcycle.
Important note: This bracket is made for -street- use. If your navigation / phone is heavy and you will be riding a lot of offroad-ing, the vibrations of heavier cockpit might crack and damage the cockpit support frame. Bear that in mind.
The bracket is made to use (aluminium) bar of diameter 15 mm, 1 mm thickness and 150 mm length with press fitted (the more pressure required, the better) inserts at both ends. I had most success with 13.20 mm inserts, but there are several more to print if you have trouble with loose fit of the insert in the tube.
Hardware
- 1x 150 mm long 15x1 mm aluminium tube
- 2x M6x30 DIN 912 Bolts (with hex head) - to attach bar to bracket
- 2x M5x25 DIN 912 Bolts (with hex head) - to attach bracket to cockpit
- At least PETG, ASA preferred - it is be used outside, PLA will not hold against the temperature and sun over time.
- At least 7 perimeters.
- 25% infill with gyroid.
Instalation
- Print both arms as displayed below (note - arms are NOT mirrored, the cover is asymetric):
- Remove original M5x12 bolts holding instruments cover.
- Place some 1mm tape on the side, which will touch the outside of the cover - it will act as additional bumper / damper:
- Press fit the inserts into both ends of the 15x1 mm tube (length 150 mm).
- Press the tube into both arms and secure it firmly with M6x30 bolts.
- Slide the bracket with securing “little arms” first at the edge of the cover and the rotate it down to the holes.
- Place the M5x25 bolts to hold both bracket and cover and tighten it securely.
- Tighten securely the M6 bolts.
- Add whatever accessory you want …
- … and rubber side down.
Note: Pokud víte jak se anglicky správně řekne hrazda, prosím o doplnění 😆