1 / 2
Convoy L21A & L21B Gaskets (SBT90.2)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Square gasket for the Convoy L21A & L21B for perfect centring of the emitter.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 134
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
The bottom hole for the SBT90.2 is 10x11mm, so make sure you place it correctly.
PLA not recommended due to 50°C heat deflection temp, starts softening.
I use ASA for 100°C HDT, but PETG should be fine for 70°C HDT.
Use white colour filament.
0.08 - 0.1mm layer height
No supports required
Note: make sure the wires are soldered on their pads correctly. I have noticed some units arriving with the wire too close to the emitter preventing the gasket to sit correctly.