Lechuza flower box holder for windowsill
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Little holder that with double tape will hold your lechuza flower pot where it belongs and no cat will toss it again.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
I had the issue that my cats started to toss down flower boxes/pots from my windowsill. And that my MIL started to water the flowers and toss the pot so far to the back that the automated window covers stuck on the edge of the flower boxes.
I thought about buying these but they cost about 20€ for EACH flower box (even on ali express..).
As i have the 50 cm version of the lechuza boxes i used 2 of these holders.
If you print them lying down, no supports are needed. I used PETG in this testprints but i will use a ABS material when my new prusa printer is arriving. PLA will be not sufficient in most cases as it will may melt in the sun.
Take double sided tape to glue them in place, if you use the TESA stuff you can easy remove it later. You are still able to remove the planting pot with out removing the holder as you can toss it a bit to the back and angle it.
I know this STL is not made with love. I have just my company laptop here atm and needed to use tinkercad. So i have not rounded up all edges and stuff like that. I may will do that later or stick with it. As it is not important, you normally do not stand 40cm infront of flower pots and look at the fastening
I received my main goals about the cats and my MIL. In addition they do not smear their dirty paws on the wall anymore when jumping down from the window sills. So it's a WIN WIN WIN <3