SV08 TPU and Foam Door Sealing Strip - now with bonus side panel strip!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Add a sealing strip to block noise and keep the heat in. Fill the gaps around the doors and the side panels.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 60
- Makes
- 1
- Views
- 625
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This TPU strip fills the gap between glass door and frame. Two versions are provided: V3 is for ≥0.8mm gaps, V4 is only 0.4mm thick and is less easy to print but may fit better. Try a short section sample print and see which is best for you.
Printed in TPU. I used a small amount of general adhesive (e.g UHU or Bostic All-purpose glue) inside the groove to grip the glass and hold the strip in place. Until the glue is in place the strip will flip out when you close the door but try it for size first before committing to glue!
On the out-side edge (underside) of the strip I fitted a 5mm x 1mm strip of foam. When the door is closed this foam pushes against the frame to seal in the heat and noise. The photo shows the foam strip in place:
The foam strip also good along the inside top and bottom of the door. This does two things: it fills the gaps and stops the door clanking on the frame. it's the same width as the black edging so it is hidden from view.
I've now added my side panel gap seal TPU strip as V2. Print and cut to length. Unscrew the panel to allow enough gap to squeeze the strip in. The design will hold itself in place when the panel is screwed back down.
These designs are “good enough” they work but I'm sure others could make improvements.
