Nespresso capsule holder version 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of my original. This now holds 30 capsules.
- Rating
- 4 / 5
- Likes
- 15
- Downloads
- 116
- Makes
- 1
- Views
- 1,221
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Updates compared to version 1.
- Center shaft increased to hold sleeve
- New base for stability and to deploy capsules from sleeve.
Build
Top section requires a brim for stability
Bottom section I placed three support paint on enforcer points to support the bridging across then opening.
After the top section is built you need to remove all the excess brim and open the gaps in the bottom. Probably don't need the inner brim.
Assembly
Fitting the top and bottom section requires all side to be equally inserted.
As this is a friction fit the tolerances are tight and maybe difficult to start but it will go (eventually).
It needs a little force to push together after lining up each side.