1 / 1
Flying Dragon Coaster
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mighty flying dragon will make sure your drinks dont scratch your table!
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 35
- Makes
- 0
- Views
- 138
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Coaster featuring a flying dragon!
No MMU/AMS required, only a single colour swap which can be done manually!
To clear any stringing (often inevitable on these 0.08 height prints, especially with wetter filament), just quickly go over the model with a lighter or hot air gun.
Diameter: 100 mm.
0.08 layer height and 100% infill strongly recommended!
For BambuLabs printers, the 3mf contains an AMS swap, in all other cases:
- Start with Black filament
- On layer 14 (height 1.2mm) swap filament to White
All my coasters use the same height swap, so you can easily print multiple on the same plate and only swap once!