SKAR: a Robotic Desk Companion

All of the parts can be printed at 0.2 layer height and any infill density you want (I printed them at 10% and they work just fine, so perhaps to lower your plastic usage, you could also go very low infill like me). The "screen bracket front" and "screen bracket back" can be printed without any supports at all, while the "bottom left part", "top right part", and the "back cover" have to be printed with supports. I printed them with organic ones, because they are easier to remove and also don't mess with other surfaces, which is quite crucial, as everything is quite a tight fit. Furthermore, some slicers might try and convince you to put supports even inside the screwholes, so tell them not to do that, as that will cause you more trouble than merit.