Nerf Rebelle Guardian MINIMAL Front Grip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Did a minimal front grip for my modified Rebelle Guardian
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 4
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Public Domain
Always wanted to replace the front grip after modding my Guardian. This version is a minimized version. It has a picatinny rail, but works without any mount. NICE!
the hardware i used is a brass spacer and some screws.
- Screws: M3 x 12mm button head socket cap screws, thread length: 12mm, thread pitch: 0.5mm, thread diameter: 3mm. https://www.amazon.com/dp/B0CGTR8VYZ
- Spacer: M3x20 Female Thread Hexagonal Hex Brass Pillar Standoff Spacer. https://www.amazon.com/dp/B07WQTF9X9
- Two wood nails, 2.5mm diameter (cut to fit)
you may have to wiggle the brass to fit, i tapped it in and wiggled it about a little to stretch it. i also cut the head and tip of the nails, then cut each nail in half, then super glued them into the supports for strength. i put the nail in a drill and reamed out the hole for the nail beforehand, to open up the hole for the nail and to rough up the inside for the glue to stick.