Two-part Drumstick Holder (4 drumsticks)

A two-part drumstick holder for vertical 1.5" (38.1 mm) drum rack tubing. The inner diameter of the holder cup and ring is 5 cm (2"), so it can hold 4 drumsticks (a bigger version for 6–8 drumsticks is available here). It clamps onto the tubing using M6x30 mm bolts (4 pcs in total, 35 mm length will fit too). There are two versions differing in the diameter of the bolt holes in the parts – one variant is prepared for M6 brass threaded inserts (hole ID 8.25 mm) and the other has 5 mm holes that can be tapped directly to accept M6 screws. In case you need a dimension between the two, you can print the 5-mm-hole variant with a large number of perimeters or a solid infill in the area using local modifiers when slicing and then drill it out to the desired spec. The clamping bracket is the same for both the ring and the cup as well as for both the "insert" and the "tap" variant, so you will need to print the same part twice.

Print instructions

Designed to print vertically (as shown in the renders) without supports. I suggest printing one mounting bracket first, test fitting it onto your rack tube and then adjusting the scale for the rest of the parts if necessary.