Shelly DIN mount Plus/Gen3/Gen4
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
1-DIN mount for Shelly Plus/Gen3/4
- Rating
- 0 / 5
- Likes
- 13
- Makes
- 0
- Views
- 1,285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Standard Digital File License
Shelly Plus, Gen3 and Gen4 compatible DIN rail mount.
Easy to Print – Prints cleanly without supports
Effortless Installation – Snaps onto the DIN rail smoothly.
Quick to Remove – Comes off just as easily when needed.
Compatible with Shelly Add-on Module
print mirrored for lora add-on so the antenna is on the outside
Slim 1 DIN Width – Takes up minimal space in the electrical panel.
Low-Profile Design – Fits neatly under the panel cover, staying out of sight.
Note! This model is not compatible with a 0-1/10v gen3 dimmer.
A practical, space-saving mount — easy to use and blends seamlessly into your setup.
3D printing settings
- 0.4mm nozzle
- 3-4 walls
- 6-10 top/bottom layers
- do not place z-seams in areas subject to bending.
- print the piece on its side with the largest flat surface against the bed.