1 / 3
charm.Fram3 - A Shaker Charm Insert for the Fram3 CMF Phone 2 Pro Cover
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A visual representation of the daydreams occupying the mind.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 1
- Views
- 260
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution
About
This model is a set of inserts for the Fram3 cover that is compatible with the CMF Phone 2 Pro.
Additional Supplies
- 1mm Acrylic (dimensions below)
- Oil (Optional, Note: Can get messy)
- A sealer (RTV silicone is recommended, but I used petroleum jelly)
- Charms
What charms can be used?
Any charm less than 3mm in height works!
Charms typically used in shaker keychains are made of acrylic, but you can 3D print your own custom charms.
1mm Acrylic Dimensions
The following dimensions have 0mm clearance.
- Top: 31mm x 31mm
- Middle: 66.5mm x 88.75mm
- Bottom: 37mm x 12mm
Required dimensions may vary due to individual printer tolerances.
Printable cutting templates have been included, but are also subject to variation printer tolerances.
Slicing & Printing
- Orient model with the open side facing up.
- Disable supports.
- Add a pause after the retaining wall is printed / before the sealing layer is printed.
- Print until the pause
- Add oil & charms
- Apply sealer to the ledge
- Place acrylic sheet
- If oil or sealer seeps onto the acrylic, clean it off or else the sealing layer will not stick!
- Continue print
All First Party Insert Sets a.k.a “Inserts I Would Use”
HERE! charm.Frame3 (Shaker Charm)
