1 / 4
MRW Joiner Ti Tube T-Nut Holder Prototype — image 1
1 / 4

MRW Joiner Ti Tube T-Nut Holder Prototype

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is the starting point for a T-Nut Holder for a Ti Tube with the MandalaRose Joiner. Adjustments will be required.

Rating
0 / 5
Likes
6
Downloads
58
Makes
0
Views
154
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The .stl is a starting point, not a destination.

Because the Ti tube inside dimensions vary so much, you will probably need to print one, then tune the scale in your slicer to get the outside dimensions to match the inside dimensions of your specific Ti tube.

Of course modifying the scale with the slicer will affect how well the t-nuts will fit in the slots so be prepared to do a little fiddling in that area after you get the correct fit In the tube. Don't worry about ‘exact t-nut fit’ as the part is only designed to hold the nut in place until you can get it attached to the cap head screw. 100% of the real work is being done by the t-nut and the screw squeezing together on the tube.

There is a 3mm hole down the middle of the part. You will want to thread that hole with an M3 screw. And maybe even use a heat insert in the end if you are really paranoid.

The hole's (and insert) sole purpose in life is to allow you to put a long M3 screw into the part to act as a handle so you can move the part back and forth in the tube and locate the t-nuts correctly. After you have attached the cap head screws to the t-nuts you can remove the handle. You'll also want to attach the handle if you ever need to remove the cap head screws as the part may want to fall into the Ti tube if unattended.

Edit 06/11/2025 - Martin Unzipped noticed there was a small anomaly on one of the faces of the print. It did not affect the usability of the part but he was kind enough to remove it and provide the resulting step file for publication here rather then create a remix. Thanks to Martin for cleaning up the part.

Tags