1 / 5
Mounting adapter for Fysetc Spider v2.2 and Pi Zero 2 W
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter to mount a Fysetc Spider v2.2 board in an Ender 5 electronics box, with a Pi Zero 2 W on side and cable routing
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 41
- Makes
- 0
- Views
- 760
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is an adapter that fits onto the standoffs on an E5 pixie enclosure box, and allow snap-in mounting of a Fysetc Spider board. It has cable guides:
- e.g. endstops and such can be run on the left side below the guide
- power in and bed and heater outputs have a guide in front and can be fixed by using a small (3 mm wide, 1 mm thick) cable tie
- Stepper driver cables can be wired on the right side under the guide there
- There are two additional slots on the right to run cables to and from the Pi Zero 2W (and potentially other auxiliaries)