1 / 1
Midlock 2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
If Midlock was so good, why didn't they make Midlock 2?
- Rating
- 5 / 5
- Likes
- 66
- Downloads
- 310
- Makes
- 4
- Views
- 1,356
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
It's like Midlock, only it's a lot thinner and uses way fewer heatsets and bolts.
Now instead of 6 screws holding the front plate to any of the 12 heatsets in the thigh plate, with pulling all 6 required to adjust the angle, there are 36 rotational steps possible, and loosening the singular screw in the middle is all that's required to adjust it.
Bill of Materials:
- All mounting methods:
- 1 x M3x15-16mm SHCS (holds the front to the back)
- (Optional but recommended) 1 x M3 washer (for the previous screw)
- 5 x M3 heatset “voron-spec” - same as used in my blasters
- Belt clamp:
- 4x M3x16-20mm SHCS (dependent on belt thickness)
- Molle and Duty belt:
- 4x M3x8mm SHCS
Build guide:
