3000GT 6G72 Camshaft Oil Seal Installation Tools (MD998761)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to replace the MD998761 Mitsubishi Special Service Tool to install 6G72 camshaft oil seals correctly.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 71
- Makes
- 0
- Views
- 224
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Public Domain
These are designed to replace the unobtainable MD998761 special service tools to install the camshaft oil seals for a 6G72 (Mitsubishi 3000GT, Dodge Stealth, etc…)
Specifically designed from measurements taken off of original, factory-installed camshaft oil seals in a 6G72TT (VR4) engine.
The short tool is used for the front bank and the long tool is used for the rear bank. They are designed to be used with the engine in the car, but also work when it's out of the car.
Print and use at your own risk, your mileage may vary.
How to use:
Follow factory service manual procedure for lubricating the camshaft oil seal. Install the seal onto the camshaft by hand and press it up to the head as parallel as you can get it. Place the installation tool on the end of the camshaft, rotating until the small indexing pin goes through the indexing hole on the tool. Hand thread the camshaft gear bolt into the camshaft, then slowly tighten it with a wrench or ratchet. Once it bottoms out, the lip on the tool will have installed the seal straight, at the correct factory depth.
Much better than trying to hammer in the seal with the available room in the engine bay.
My print settings:
Polymaker Polylite ASA
55% Cubic Infill
4 line wall thickness
4 layer horizontal shells
Make sure you flip the models so that the lip is on the top.
Edit: V3 had a previous version for the rear camshaft tool, I've corrected it with the proper depth in V4.
