Toothbrush wall holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cabinet style wallmounted toothbrush holder with magnet latch
- Rating
- 4.5 / 5
- Likes
- 18
- Downloads
- 133
- Makes
- 2
- Views
- 619
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This wall mount prevents your toothbrushes from falling, keeps then shielded from any dirt and when using strong magnets is perfect for use in a caravan, boat etc. The design aims to be light, low profile and easily printable. Most regular toothbrushes should fit without issue.
I printed in PETG but most materials should work fine. I recommend at least 3 walls. There is not too much infill so it doesn't matter that much. No supports are required and parts are pre-oriented for printing. If you need the hinge to be on the other side remember to mirror both parts.
Assembly
Glue two 8x2mm magnets to the holes. I used just a drop of superglue. Make sure to get the polarity right. Clean the mating surfaces of the hinge by filing or sanding slightly until they fit together. Drill the hinge holes if required. Insert a piece of filament into the hole and lock in place with a quick tap of a soldering iron. Mount with screws from the holes or use double sided tape.