Keychron K1 Clip-on Feet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple clip-on keyboard feet for the Keychron K1. It raises the back 13mm off the table surface.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 217
- Makes
- 4
- Views
- 1,753
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
Simple clip-on keyboard feet for the Keychron K1. It raises the back 13mm off the table surface. It's thin enough to fit between the two switches above the F1 keys. There's also a tab on the back to allow easier removal, since you can't slide it off due to the existing small rubber feet.
I used PLA but I would think PETG would be fine too. It will slide around on a hard surface, so you may still need some kind of rubber surface underneath for non-slip. I tried printing in TPU as well and this does work and help with slip, but doesn't hold as well to the keyboard.
Enjoy!