1 / 1
FLAK Sideplate Screw Cap
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cap for the empty screw hole in the sideplate of the FLAK nerf rifle.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 12
- Makes
- 0
- Views
- 324
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a cap for the screw hole in the Sideplate print for Captain Slug's FLAK nerf rifle.
I did a bit of sanding to make the cap sit flush (and help the stain take), then added a touch of superglue and pressed the cap into the side plate. Note that the fit was tight enough without superglue that I had to pry the cap out with tweezers. I'd recommend removing the U channel before doing that.
Printed using SUNLU Wood PLA on a 0.4mm nozzle at 0.15mm layer height. I used a brim for bed adhesion, and the print took under 10 minutes.