1 / 4
10 inch rack shelf for 3.5/2.5 drives and flexatx psu — image 1
1 / 4

10 inch rack shelf for 3.5/2.5 drives and flexatx psu

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

10" rack shelf for disks and FlexATX PSU. Designed for 200mm deep rack

Rating
0 / 5
Likes
6
Downloads
33
Makes
0
Views
648
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

10" rack shelf for disks and FlexATX PSU. Designed for 200mm deep rack

When i replaced one of my 4U 19" rack mounted computer with a MS-01 i was looking around for 10" rack shelf to mount the disks and PSU on but i didn't find anything i liked so i decided to design my own.

I had a few goals with the design, first it had to easily fit on my print bed so at a minimum the rack ears must be separate.
Secondly i wanted some flexibility so i don't have to reprint the whole shelf if my needs change later.

What i came up with is a 10" rack shelf split in the middle where each half can be rotated 180 degrees and still work fine.
This allows combing two disks, or a disk + PSU or just PSU and a blank side.

I'm using this shelf together with this rack:
https://www.printables.com/model/1173696-3d-printable-rack-10-inch-and-6-inch

Required parts

  • M3x10mm countersunk screws (rack ears and the join)
  • M3x10mm for connecting the two front parts
  • M3 hex nuts
  • M5x20mm for screwing the shelf into the rack (+ M5 hex nuts)

Printing

I have included a prusaslicer project file with some examples.
There is several parts included that is intended as optional modifiers, for example to create a hole behind the disk for cables and to create a grid in the front.

Some support is needed for the base in the middle

It is also possible to take advantage of the fact that the “left” and "right" parts is modeled together so if you don't like to have a split in the middle (and save 8 screws per shelf) you can add a left and a right part to the slicer as a multipart object and the two sides should line up perfectly.
There is an example of this in the project file as well.

I have also created a 92mm fan holder that goes between 3 shelfs.
I recommend that you also print a fan grill to prevent cables from accidentally poking in to the fan.

Assembly

Assemble the two base parts first then join the two front parts with two screws in the middle and finally attach the front to the base.

The important part is that once you have mounted a disk to the shelf some screw holes will be blocked and very difficult to access.

Note: when attaching a disk from the underside using 6-32 screws (the normal "computer screws" that is not M3, most likely applies only for 3.5" disks) the head must not be too big or it wont fit in the hole.
 

Tags