Ω-series Trapezoidal Drawer Pulls & Knobs (Counterbore version)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
No supports needed. I have opted to use a Diamond-style 3D effect plate with a Hilbert-curve for first layer for extra fanciness.
There are 3 “styles” to choose in 3 “sizes”
Styles
- Knobs (one insert, relatively narrow)
- Pull (two inserts, solid)
- Blind (two inserts, finger space on the underside)
- Handle (two inserts, handle with an open space behind it)
Sizes
- Small (16mm-based)
- Medium (24mm-based)
- Large (32mm-based)
The “Extended” sizes are the same width and length (and thus also hole spacing), but have an additional ½ Basis in Height.
All models take M4 caphead screws. For styles that take two screws, to find the on-center distance between the holes take the nominal width of the model and subtract the Base size. For example, a Medium handle of 96mm nominal width, the bolts will be spaced 72mm apart (96mm - 24mm). Note that the actual sizes of all the handles are smaller than their listed nominal size.
For Bolt lengths
- Small: 12mm minimum, 16mm recommended
- SmallExt: 18mm minimum, 20mm recommended
- Medium: 20mm minimum, 25mm recommended
- MediumExt: 30mm minimum, 35mm recommended
- Large: 25mm minimum, 30mm recommended
- LargeExt: 35mm minimum, 40mm recommended