Cap and Sleeve for cheeep AliE telescoping fibreglass mast
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cap and sleeve for a cheap fibreglass telescoping pole from AliE.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 84
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I picked up a new fibreglass pole from AliE which arrived with the end caps shattered in shipping... I printed up some new end caps, and made the outer diameter fit the inner diameter of my POTA ground spike tightly (as seen in the photo).
This version of the top cap is a new version, not shown in the photo. I still need to print this latest version and upload…
The measured inner diameter of the top cap is 32mm, which is a very tight fit (intentionally). The cap itself is 33mm, with ‘ribs’ to provide a suitable friction fit, along with loops for a piece of bungie cord so I don't loose the cap.
The measured inner diameter of the bottom sleeve is 33.4mm which required some rubber mallet persuasion to gently seat it fully onto the bottom of the pole. This was intentional since I wanted the base sleeve/cap to be a permanently mounted piece.