1 / 3
6 Point Base Remix of the Ultimate Cereal Container Filament Drybox — image 1
1 / 3

6 Point Base Remix of the Ultimate Cereal Container Filament Drybox

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix of the Base, PolyDryer Adapter, and Desiccant Holder from The Ultimate Cereal Container Filament Drybox system.

Rating
4 / 5
Likes
12
Downloads
118
Makes
1
Views
1,059
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

6 Point Base Remix of the Ultimate Cereal Container Filament Drybox by GunplaMark

  • Remix of the Base.
    • Includes 2 more connection points (One Front and One Rear) meant to hold a hydrometer.
       
  • Remix of the Base Cover and a Desiccant Cage.
    • The two snap together and helps keep from spilling desiccant.
       
  • A new Vent.
    • Matches the look of the base covers, and helps redirect hot air from the polydryer to the back of the drybox. I have not done any proper testing, but without the vent I could feel cold spots on the drybox during drying. With the vent the temperature seems to be more evenly distributed.
       
  • Remix of the Polydryer Adapter.
    • Removed excess material and shrunk the overall size. The inlet/exhaust separator fin extends slightly to meet flush with the vent insert. Also includes an Air Exchanger inspired by the PolyDryer Air Exchanger by gwg. Again I have not done any proper testing but do feel that it makes a difference in drying quality and time.
       
  • Connection Point Plug.
    • Insert to fill any unused connection points. Was intended to fill the gap left in the rear connection point if the Desiccant Cage was not used. Also works well just for looks.
       
  • Remix of Hydrometer and Tag holders.
    • I included a tag holder as well, though I personally do not use it.

 

I am using the Ultimate Filament Drybox Coupler Hole Jig by Phil Caruso for the spacing of my bowden connectors, if yours are lower they will interfere with the hydrometer and tag holders.
 

Printed in Prusament ASA
.20mm Speed Profile
10% Honeycomb Infill
With Brims. (Be sure to use Outer only on the Vent, Base Cover and Desiccant Cage or you will be picking plastic out of every little slot in the grill.)

The Dryer Adapter has a real bad habit of warping on the ends, I got the best results printing it on its own at a 45° angle in the center of the plate.
I also used Jet Black ASA with fuzzy skin set to .1 thickness and .1 point distance to better match the look and texture of the polydryer.

 

 

Fair Warning:
As of posting this I've only just picked up 3d printing a few months ago. I'm still learning how to use the printer and modeling software let alone how to correctly model things for 3d printing. And, this is the biggest rabbit hole I've fallen down yet. There WILL be issues and quirks with these models. I'm very much open to suggestions and looking forward to seeing any changes more experienced people make.

 

Additional note, I somehow managed to break the model while working on the dryer adapter and didn't notice until I was hours in. I could not for the life of me figure out where the issue was let alone how to fix it.
Edit: The step file of the model would load for me in prusa slicer but not orca. I've uploaded an stl and it seems to load in both now.

Tags