1 / 14
Focuser cover - Skywatcher Crayford Focuser 2" on Newton Telescopes — image 1
1 / 14

Focuser cover - Skywatcher Crayford Focuser 2" on Newton Telescopes

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Focuser cover to keep light (as far as possible) out. Suitable for Skywatcher Crayford Focusers 2" on Newton Teleskopes

Rating
0 / 5
Likes
2
Downloads
13
Makes
0
Views
195
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

Taking dark images with my Newtonian telescope in daylight with just the telescope lid on was impossible - the result was a very bright light and overexposed picture.

When I investigated where the light was coming from, I found that it most of it was coming from the focuser.  - see pictures (30 second exposure, ISO 1600, astromodified DSLR) .


The test pictures were taken with a headlamp as light source (after sunsetting).

  • The headlamp was shone on the gap in the focuser, between the outside of the tube and the Crayford body, bottom of the telescope on the carpet floor ("covered").
  • So I equiped the focuser tube with adhesive film black Velour Velvet fabric on the outside to reduce the gap. The result was much better, but still too much light shining through the focuser.
  • So I designed a cover to reduce the incidence of light through the focuser even more.

    Focuser covered with the new 3D-printed cover, bottom covered (on the carpet floor), headlamp was shone on the new focuser cover.

Still not perfect but as mentioned - strong light from the headlamp directly onto the cover.

It is still possible to cover the slats with adhesive tape.

The cover was designed with slats to be as near as possible to the outside of the tube (black Velour velvet) but still ensure smooth running (more or less).
 

 

Models

There are two models, one with 30 and one with 60 slats. I prefer the one with 60 slats but if you have printing problems try the model with 30 slats.

FreeCAD models are also available if you want to modify the model.

 

Printing

About 14 grams. PETG is recommended (flexibility of the slats).

Nozzle 0.4 mm, layer height 0.2 mm, no brim, no support, 3 wall loops.

Keep the speed of the first layer low, about 15 to 25 mm/s (depending on the adhesion of the bed) due to the small slats.

 

-------------------------------
The only reward for a hobbyist is likes.

Support / Donation for my work